IBM 866631Y - Netfinity 7100 - 8666 Hardware Maintenance Manual page 39

Table 5. UNIX LLI driver messages for the Ethernet controller (continued)
pnt0-14 Cannot locate hardware.
Explanation:The SunSoft Solaris driver cannot find any Ethernet controller.
Action:Verify that the Ethernet controller is enabled. If the Ethernet
controller is enabled, run the diagnostic programs.
pnt0-15 No more devices to open.
Explanation:The SunSoft Solaris driver cannot find any more Ethernet
controllers. Action:Verify that additional IBM Netfinity 10/100 Fault
Tolerant Adapters are present or replace the Ethernet adapter that fails to
respond. If the problem persists, run the diagnostic programs.
pnt0-17 Device fault...Reset initiated!
Explanation:The SunSoft Solaris driver has been reset due to a device fault.
Action:Verify that additional IBM Netfinity 10/100 Fault Tolerant Adapters
are present or replace the Ethernet adapter that fails to respond. If the
problem persists, run the diagnostic programs.
pnt0-19 IRQ found for PCnet hardware does not match space.c (or pnt.conf)!
Explanation:This is a warning message referring to the interrupt request
(IRQ) that the SunSoft Solaris driver found in the system. Action:Ignore this
message if you are sure that this is what you want to do. Otherwise, run
the NETCONFIG program to match the hardware settings
pnt0-20 add_intr_handler failed! Unknown interrupt type.
Explanation:The interrupt request (IRQ) that was specified, or the IRQ that
was found, conflicts with other devices in the server. Action:
v
Modify the hardware settings.
v
Run the NETCONFIG program to search for another Ethernet controller.
pnt0-21 add_intr_handler failed! Out of range interrupt number.
Explanation:The interrupt request (IRQ) that was specified, or the IRQ that
was found, conflicts with other devices in the server. Action:
v Modify the hardware settings.
v Run the NETCONFIG program to search for another Ethernet controller.
pnt0-22 add_intr_handler failed! Out of range IPL.
Explanation:The interrupt request (IRQ) that was specified, or the IRQ that
was found, conflicts with other devices in the server. Action:Modify the
hardware settings. Run the NETCONFIG program to search for another
Ethernet controller.
pnt0-23 add_intr_handler failed! Vector already occupied.
Explanation:The interrupt request (IRQ) that was specified, or the IRQ that
was found, conflicts with other devices in the server. Action:Modify the
hardware settings.
pnt0-24 add_intr_handler failed! Vector already shared at different IPL.
Explanation:The interrupt request (IRQ) that was specified, or the IRQ that
was found, conflicts with other devices in the server. Action:
v Modify the hardware settings.
v Run the NETCONFIG program to search for another Ethernet controller.
29
Diagnostics