IBM 866631Y - Netfinity 7100 - 8666 Hardware Maintenance Manual page 137

Error Code/Symptom
165-XXX-000 (Failed
Service Processor test)
180-XXX-
000(Diagnostics LED
failure)
180-XXX-001 (Failed
information LED panel
test)
180-XXX-002 (Failed
Diagnostics LED Panel
test)
180-XXX-003 (Failed
System Board LED test)
180-XXX-004 (Failed
Processor Board LED
test)
180-XXX-005 (Failed
SCSI Backplane LED
test)
180-XXX-006 (Memory
Board LED test)
201-XXX-0NN (Failed
Memory test, see
"Memory Settings" on
page 34.) NN = DIMM
location.
201-XXX-999 (Multiple
DIMM failure, see error
text.)
202-XXX-001 (Failed
System Cache test)
202-XXX-002 (Failed
System Cache test)
202-XXX-003 (Failed
System Cache test)
202-XXX-004 (Failed
System Cache test)
FRU/Action
1. Check error log for any I2C messages (see "I2C bus fault
messages" on page 141).
2. Remove ac power from system for 20 seconds, then rerun
service processor test. If problem persists, proceed to step 3.
3. I/O Legacy Board. Before replacing the I/O Legacy Board,
ensure that I/O Legacy Board jumper J28 is not installed (the
default) when the error occurs.
1. Run Diagnostic LED test for the failing LED.
1. Information LED Panel
2. Diagnostic LED Panel
3. I/O Legacy Board
1. Diagnostics LED Panel
2. I/O Legacy Board
1. System Board
1. Processor/PCI Board
2. I/O Legacy Board
1. SCSI Backplane
2. SCSI Backplane Cable
3. I/O Legacy Board
1. Memory Board
2. Processor/PCI Board
3. I/O Legacy Board
1. DIMM Location J1-J16
2. Memory card
1. See error text for failing DIMMs
2. Memory card
1. VRM 1
2. Microprocessor CPU 1
1. VRM 2
2. Microprocessor CPU 2
1. VRM 3
2. Microprocessor CPU 3
1. VRM 4
2. Microprocessor CPU 4
127
Symptom-to-FRU index