3. Remove the top cover (see "Removing the top cover" on page 45).
4. Remove all hot-swap hard drives.
Note: When you reinstall the hot-swap hard drives after replacing the SCSI
Backplane, each drive will need to be replaced in the same bay from
which it was removed.
5. Remove the shuttle (see "Removing the shuttle" on page 116).
6. Remove the vertical hot-swap fan assembly.
7. Grasp the handhold and lift the SCSI backplane assembly with backerplate up
and out of the server.
8. To install the SCSI backplane assembly, reverse the above procedure.
FRU information (service only)
117