Diagnostic Error Codes - IBM 866631Y - Netfinity 7100 - 8666 Hardware Maintenance Manual

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or 197 do not replace a
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to abort the test.
197 This is a warning error and may not indicate a hardware failure.
For all error codes, replace/follow the FRU/Action indicated.
Error Code/Symptom
001-XXX-000 (Failed
core tests)
001-XXX-001 (Failed
core tests)
001-250-000 (Failed
System Board ECC)
001-250-001 (Failed
Processor Board ECC)
005-XXX-000 (Failed
Video test)
011-XXX-000 (Failed
COM1 Serial Port test)
011-XXX-001(Failed
COM2 Serial Port test)
014-XXX-000(Failed
Parallel Port test)
015-XXX-001 (USB
interface not found.
Board damaged.)
015-XXX-015 (Failed
USB External Loopback
Test)
015-XXX-198 (USB
device connected
during USB test)
020-XXX-000 (Failed
PCI Interface test)
020-XXX-001(Failed
Hot-Swap Slot 1 PCI
Latch test)
020-XXX-002 (Failed
Hot-Swap Slot 2 PCI
Latch test)
020-XXX-003 (Failed
Hot-Swap Slot 3 PCI
Latch test)
FRU/Action
1. Processor/PCI Board
1. Processor/PCI Board
1. Processor/PCI Board
1. Processor/PCI Board
1. Video Adapter (if installed)
2. I/O Legacy Board
1. I/O Legacy Board
1. I/O Legacy Board
1. I/O Legacy Board
1. I/O Legacy Board.
1. Make sure parallel port is not disabled.
2. Re-run USB External Loopback Test.
3. I/O Legacy Board
1. Remove USB devices from USB1 and USB2.
2. Re-run test.
3. I/O Legacy Board
1. Processor/PCI Board
2. System Board
1. PCI Hot-Swap Latch Assembly
2. Processor/PCI Board
1. PCI Hot-Swap Latch Assembly
2. Processor/PCI Board
1. PCI Hot-Swap Latch Assembly
2. Processor/PCI Board
125
Symptom-to-FRU index