IBM 866631Y - Netfinity 7100 - 8666 Hardware Maintenance Manual page 94

9. Configure the Network Drivers.
84
Hardware Maintenance Manual: Netfinity 7100 – Type 8666
v System Partition Access (requires System Partition)
v Update Connector Manager (available only on systems running Windows NT
4.0 or later)
v System Profile
v Web Manager Configuration (installed only if the Netfinity Manager
Installation with Web Enhancement installation configuration is selected)
Note: The graphical user interface (GUI) program files for DMI Browser, ECC
Memory Setup, System Partition Access, RAID Manager, and Predictive
Failure Analysis will be installed regardless of whether the system has a
DMI Service Layer, ECC Memory, a System Partition, a RAID adapter, or
a PFA-enabled disk drive. This enables a network administrator to
remotely access these services on other systems within a network.
However, the base program that enables local use of the service will be
installed only if the required hardware or system configuration is
present.
If the installation configuration allows for network access, enter information
regarding the communication protocols that are supported by the system. The
Network Driver Configuration window will appear.
Follow these steps to continue configuring the system:
a. Enter a System Name.
Enter a name for the system in the System Name field. This name will help
other Netfinity Manager users identify the system on the network.
b. Select a Network Driver.
Select one of the available Network Drivers that are displayed in the
Network Drivers field. Once selected, the Network Driver will assign a
network address to the system.