Configuring the Quantum Board
Double click the board's icon in the Boards window to open the Board
Configuration window.
Figure 16. Board Configuration window (Quantum Board)
Use the Board Configuration window for the Quantum board to view the
following attributes:
•
Board Info: the Board Logical ID (assigned by AltiServ) and Board
Name (the type of board installed in the system and board ID).
For Quantum boards in a Windows 2000 system, please note:
— the physical board ID 0 is not supported
— the valid physical board IDs are 1-15
•
Channel Mapping List: the Logical Channel, Physical Span and
Physical Channel for the entire board. To reset the channel, select the
channel to reset and click the Reset Channel button, then click OK.
Depending on whether the channel is a line or a trunk
line, double clicking a channel in this window invokes
either a Pine Properties window (see "Quantum Line
Properties" on page 93, or a Trunk Line Properties window see
("Quantum Trunk Properties" on page 74).
•
Span Info: not available for Quantum boards.
Configuring the Quantum Board
AltiWare OE System Administration Manual
55