3.2
Executing the Diagnostic Test
Toshiba MS-DOS is required to run the DIAGNOSTICS PROGRAM. To start the
DIAGNOSTIC PROGRAM, follow these steps:
1. Connect a wraparound connector to the I/O adapter's printer port and RS-232C port.
Connect the I/O adapter to the computer. Next, connect the FDD and insert the
diskette containing the test program
2. Turn on the computer and the test program will execute and the test menu will be
displayed.
The following menu will appear:
TOSHIBA personal computer
version X.XX (c) copyright TOSHIBA Corp. 19XX
DIAGNOSTICS
1 - DIAGNOSTIC TEST
2 - HARD DISK FORMAT
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING TEST
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
0 - SETUP
NOTE: To exit the DIAGNOSTIC TEST MENU, press the Esc key. If a test program is in
progress, press Ctrl + Break to exit the test program, or press Ctrl + C to stop the test
program.
xxx DIAGNOSTICS
MENU :
File No. 960-140
3-3