File No. 960-140
Installing the Display Assembly
To install the display assembly follow the steps below. (See figures 4-8 to 4 -11.)
1. Seat the display assembly and connect the microphone cable to PJ470 on the
system board.
2. Connect the display flexible cable to PJ250 on the system board (figure 4-9).
3. Lay the metal cover in place, making sure the cover is properly aligned with the edges
of the computer.
4. Route the RTC battery cable in its groove and secure it with insulator.
5. Close the display, turn the computer upside down, and fasten the display with five
M2x14 silver screws.
6. Install removed components.
4-16