Toshiba Libretto 100CT User Manual page 136

(b) Parallel Port Mode
This option in this tab are ECP and Standard Bi-directional.
ECP
Std. Bi-Direct.
(c) Hard Disk Mode
Use this item to select the hard disk mode.
Enhanced IDE
(Normal)
Standard IDE
NOTE: Formats for Enhanced IDE and Standard IDE are different, so if you
change the setting, you will have to reformat the hard disk for the appropriate
setting.
4. Boot Priority
Use this option to select the disk drive priority for boot up.
FDD HDD:
HDD FDD:
You can reverse the order by holding down the F10 key while the computer is
booting. This procedure alternates the setup setting.
Sets the port mode to Extended Capabilities Port
(ECP). For most printers, the port should be set to ECP.
(Default)
This setting should be used with some other parallel
devices.
Select this mode when using MS-DOS®.
Windows for Workgroups, Windows 95 or OS/2®.
(Default)
Select this mode when using Novell® NetWare® or
UNIX®. When this mode is selected, up to 504MB is
logically available even though the disk's capacity is
larger than 504MB.
The computer looks for bootable files first on
the FDD and next on the HDD. (Default)
The computer looks for bootable files first on
the HDD and on the FDD.
File No. 960-140
3-61