Hard Disk Test - Toshiba Libretto 100CT User Manual

File No. 960-140
3.11

Hard Disk Test

To execute the Hard Disk Test, select 8 from the DIAGNOSTIC TEST MENU, press Enter,
and follow the directions on the screen. The hard disk test contains ten subtests that test the
hard disk drive functions.
NOTE: The contents of the hard disk will be erased when subtest 02, 03, 04, 05, 06, 08,
09, or 10 is executed. Before running the test, the customer should transfer the
contents of the hard disk to floppy disk. If the customer has not or cannot
perform the back-up, create back-up disks as described below.
Check to see if the Microsoft Create System Disks Tools (MSCSD.EXE) still
exists in the System Tools Folder. (This tool can be used only once.) If it exists,
use it to back up the pre-installed software, then use the Backup utility in the
System Tools folder to back up the entire disk, including the user's files.
Refer to the operating system instructions.
The following messages will appear after selecting the hard disk test from the DIAGNOSTIC
TEST MENU. Answer each of the questions with an appropriate response to execute the test:
[HDD test parameters]
Test drive number
HDC F/W error retry
Data compare error dump
Detail status display
:Select items, Enter:Finish, Esc:Exit,F5:Set default
1. Select the hard disk drive number to be tested:
Test drive number
2. This message is used to select the retry operation when the hard disk controller detects
an error. Select yes or no .
HDC F/W error retry
3. This message is used to select the error dump operation when a data compare error is
detected. Select yes or no :
Data compare error dump
3-26
:#1
:yes
:no
:no
HDD#1
HDD#2
HDD1&2
yes
no
yes
no