File No. 960-140
4.13 I/O Adapter Board
Removing the I/O Adapter Board
To remove the I/O adapter board follow the steps below. (See figures 4-30 to 4-32.)
1. Remove the I/O adapter from the computer. Disconnect all the external cables from
the I/O adapter.
2. Turn the I/O adapter upside down, and remove three M2x5 silver screws from the
back and six M2x5 silver screws from the bottom.
3. Release one latch securing the left side, two latches securing the front edge and one
latch securing the right side and then remove the upper cover.
4. Remove four M2x4 screws securing the I/O adapter board and lift out the board.
4-36
Figure 4-30 Removing nine screws
Figure 4-31 Removing the upper cover