The Front Panel - TP-Link TL-WA7510N User Manual

TL-WA7510N
View from left to right, the parts are explained below.
RP-SMA: This is where you can connect an outside antenna. For this AP, the antenna is built
inside, and usually there is no necessity to connect an outside one.
LAN: This port is used to connect to the POE port of the provided Power Injector.
Reset:
There are two ways to reset the AP's factory defaults:
• Use the Factory Defaults function on System Tools -> Factory Defaults page in the
AP's Web-based Utility.
• Use the Factory Default Reset button: Press and hold the Reset button until Wireless
Signal Strength LEDs flash, and then the AP will reboot.
Note:
Ensure the AP is powered on before it restarts completely.

1.4.2 The Front Panel

TL-WA7510N consists of several LED indicators, which is designed to indicate connections and
wireless signal.
View from left to right, the details are explained below.
Name Status
Off
PWR
On
Off
LAN On
Flashing
Wireless Off
Signal
On
Strength
5GHz 150Mbps Outdoor Wireless Access Point User Guide
Figure 1-2 Front Panel sketch
There is no device linked to the corresponding port
There is a device linked to the corresponding port but no activity
There is an active device linked to the corresponding port
There is no remote wireless signal
Indicates the wireless signal strength of a remote AP
Table 1-1 the LED Description
4
Indication
No Power
Power on
Client or
Repeater
mode