Ap Router Mode - TP-Link TL-WA7510N User Manual

TL-WA7510N
Figure 2-5 Hardware Installation of the TL-WA7510N in Standard AP -- Bridge mode
1. Connect the LAN port of TL-WA7510N to the POE port of the Power Injector with an Ethernet
cable.
2. Plug one end of the Power Adapter into the DC jack on the Power Injector, and the other end
in electrical wall socket.
3. Power on the PC(s).
Note:
It is recommended that you connect a PC/notebook to the LAN port of the Device with an Ethernet
cable, and then login the Device from the PC/notebook to set the Device in Bridge with AP mode.

2.3.2 AP Router Mode

Figure 2-6 Hardware Installation of the TL-WA7510N in AP Router mode
1. Connect the LAN port of TL-WA7510N to the POE port of the Power Injector with an Ethern
cable.
2. Connec t the DSL/Cable Modem to the LAN port of the Power Injector with an Ethernet cable.
3. Plug one end of the Power Adapter into the DC jack on the Power Injector, and the other end
in electrical wall socket.
4. Power on the PC(s) and
Note:
In this mod e, the LAN port of the Power Injector (connected to the LAN port of the Device) works
as the WAN port.
5GHz 150Mbps Outdoor Wireless Access Point User Guide
other connected devices (such as the ADSL modem).
9
et