TP-Link TL-WA7510N User Manual page 40

TL-WA7510N
Password - If the AP your Device is going to connect needs password, you need to fill the
password in this blank.
Dynamic IP- When the Device connects to a DHCP server, or the ISP supplies you with
DHCP connection, please choose this type. The Device will get the IP address automatically
from the DHCP server or the WISP if you choose the Dynamic IP type.
If you choose Dynamic IP in Figure 3-25 and then click Next, the wireless setting page as in
Figure 3-27 will appear.
Static IP - In this type, you should manually fill in the IP address, Subnet Mask, Default
Gateway, and DNS IP address, which are specified by your ISP.
1) If you choose Static IP in Figure 3-25 and then click Next, Figure 3-28 will appear.
IP Address- This is WAN IP address as seen by external users on the Internet (including
your ISP). Enter the IP address into the field.
Subnet Mask- It is used for the WAN IP address, which is usually 255.255.255.0.
Default Gateway- Enter the default gateway in the blank if required.
Primary DNS- Enter the DNS IP address in the blank if required.
Secondary DNS- If your WISP provides another DNS IP address, enter it in this field.
Note:
The IP parameters should have been provided by your WISP.
2) After you have entered the above necessary parameters and then click Next, the wireless
setting page as in Figure 3-27 will then appear.
2. When you finish the wireless setting in Figure 3-27 and click Next, then Figure 3-29 will
appear, where you can click Finish button to complete the Quick Setup.
5GHz 150Mbps Outdoor Wireless Access Point User Guide
Figure 3-28
Figure 3-29
32