CHAPTER 4
Installing Modules
Overview
Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to install and remove modules. For information about
managing installed modules, see JunosE System Basics Configuration Guide, Chapter 6,
Managing Modules.
This chapter contains the following sections:
Slots for line modules, switch route processor (SRP) modules, and switch fabric module
(SFM) modules are located in the front of the router, while slots for input/output adapters
(IOAs) and SRP IOAs are located in the rear.
In the E320 Broadband Services Router, modules mount vertically in a 15-slot chassis,
numbered left to right (0-16). See Figure 12 on page 26 and Figure 13 on page 27 for
front and rear views of the router.
25