Configuring The Management Ethernet Interface - Cisco CRS-1 - Carrier Routing System Router Getting Started Manual

Configuring the Management Ethernet Interface

RP/0/RP0/CPU0:router(config)# interface MgmtEth ?
0/RP0/CPU0/0
Configuring the Management Ethernet Interface
To use the Management Ethernet interface for system management and remote communication, you must
configure an IP address.
Prerequisites
To configure the Ethernet Management port for network communications, you must enter the interface
network addresses and subnet mask. Consult your network administrator or system planner for this
information.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
5-4
MgmtEth Interface Instance
configure
interface MgmtEth0/slot/CPU0/0
ipv4 address ipv4 address subnet-mask
no shutdown
commit
end
show interfaces MgmtEth0/slot/CPU0/0
Chapter 5 Initial Configuration of the Cisco IOS XR Software