Configuring The Management Interface Using The Cli - Cisco WLC 5700 Series Interface Configuration Manual

Configuring the Management Interface using the CLI

• Do not map a guest WLAN to the management interface. If the EoIP tunnel breaks, the client could
• Do not configure wired clients in the same VLAN or subnet of the service port of the controller on the
Configuring the Management Interface using the CLI
Before You Begin
You must use the following steps to configure management interfaces on the controller. You can also use
these steps to configure the AP manager interfaces on the controller. These general instructions apply to all
management interfaces.
SUMMARY STEPS
1. show ip interface brief
2. config terminal
3. wireless management interface vlan vlanID
4. end
5. show wireless interface summary
DETAILED STEPS
Command or Action
Step 1
show ip interface brief
Step 2
config terminal
Step 3
wireless management interface vlan vlanID
Step 4 end
Step 5 show wireless interface summary
Configuring the Management Interface
This module contains the following topics:
Interface Configuration Guide, Cisco IOS XE Release 3E (Cisco WLC 5700 Series)
48
obtain an IP and be placed on the management subnet.
network. If you configure wired clients on the same subnet or VLAN as the service port, it is not possible
to access the management interface of the controller.
Purpose
Displays all the interfaces in the controller.
Enters global configuration mode.
Creates a management interface by providing the values for
the VLAN (VLAN identifier).
Returns to EXEC mode.
Displays all the wireless interfaces in the controller.
Configuring Management Interfaces
OL-32314-01