Entering Rom Monitor Mode - Cisco CRS-1 - Carrier Routing System Router Getting Started Manual

Entering ROM Monitor Mode

Command or Action
Step 8
end
Example:
RP/0/RP0/CPU0:router(config)# end
Step 9
reload
Example:
RP/0/RP0/CPU0:router# reload
When you place the primary RP in ROMMON mode, the system will fail over to the standby RP, which
Note
then becomes the primary. If the router contains two RPs, repeat these steps for the second RP. Both RPs
must be in ROMMON mode.
Examples
The following examples are provided:
•
•
Verifying the Router State: Example
The following example shows the redundancy roles of both RPs and shows that both are operating in
HFROS-RUNNING state:
RP/0/RP0/CPU0:router# show redundancy
This node (0/RP0/CPU0) is in ACTIVE role
Partner node (0/RP1/CPU0) is in STANDBY role
Standby node in 0/RP1/CPU0 is ready
RP/0/RP0/CPU0:router# show platform
Node
-----------------------------------------------------------------------------
0/2/SP
0/2/CPU0
0/3/SP
0/3/CPU0
0/RP0/CPU0
0/RP1/CPU0
0/SM0/SP
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
A-4
Verifying the Router State: Example, page A-4
Placing the System in ROM Monitor Mode: Example, page A-5
Type
L3LC(SP)
L3LC
L3LC(SP)
L3LC
RP(Standby)
RP(Active)
S123(SP)
Purpose
Exits global configuration mode.
Reloads the system to enter ROM monitor mode.
PLIM State
N/A HFROS-RUNNING
16 port OC48 HFROS-RUNNING
N/A HFROS-RUNNING
8 port 10GE HFROS-RUNNING
N/A HFROS-RUNNING
N/A HFROS-RUNNING
N/A HFROS-RUNNING
Appendix A ROM Monitor Guide
Config State
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON
PWR,NSHUT,MON