Verifying The System After Initial Bring Up; Examples Of Show Commands - Cisco CRS-1 - Carrier Routing System Router Getting Started Manual

Chapter 4 Bringing up a New Cisco CRS-1 Router

Verifying the System After Initial Bring Up

Perform the following procedure to verify the status of the router.
SUMMARY STEPS
1.
2.
3.
4.
DETAILED STEPS
Command or Action
Step 1 show version
RP/0/RP0/CPU0:router# show version
Step 2 show platform
RP/0/RP0/CPU0:router# show platform
Step 3
show redundancy
Example:
RP/0/RP0/CPU0:router# show redundancy
Step 4
show environment
Example:
RP/0/RP0/CPU0:router# show environment

Examples of show Commands

The following sections provide examples of show commands:
•
•
•
•
show version
show platform node-id
show redundancy
show environment
show version Command, page 4-10
show environment Command, page 4-10
show platform Command, page 4-11
show redundancy Command, page 4-12
Bringing Up a Single-Chassis System for the First Time
Purpose
Displays information about the router, including image
names, up time, and other system information.
Displays information about the status of cards and modules
installed in the router.
Type the show platform nodeId command to display
•
information for a specific node.
Displays the state of the primary (active) and standby
(inactive) RPs, including the ability of the standby to take
control of the system.
Displays information about the hardware attributes and
status.
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
4-9