How To Perform Advanced Management Ethernet Interface Configuration; Configuring A Management Ethernet Interface - Cisco 6000 Series Configuration Manual

Advanced Configuration and Modification of the Management Ethernet Interface
How to Perform Advanced Management Ethernet Interface
Configuration
This section contains the following procedures:

Configuring a Management Ethernet Interface

Perform this task to configure a Management Ethernet interface. This procedure provides the minimal
configuration required for the Management Ethernet interface.
Note
You do not need to perform this task if you have already set up the Management Ethernet interface to enable
telnet servers.
SUMMARY STEPS
1. configure
2. interface MgmtEth interface-path-id
3. ipv4 address ip-address mask
4. mtu bytes
5. no shutdown
6. Do one of the following:
7. show interfaces MgmtEth interface-path-id
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:routerconfigure terminal
Step 2 interface MgmtEth interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface MgmtEth
0/RP0/CPU0/0
Step 3 ipv4 address ip-address mask
Interface and Hardware Component Configuration Guide for Cisco NCS 6000 Series Routers, IOS XR Release 6.4.x
• end
• or
• commit
• or

How to Perform Advanced Management Ethernet Interface Configuration

Purpose
Enters XR configuration mode.
Enters interface configuration mode and specifies the
Ethernet interface name and notation rack /slot /module
/port .
The example indicates port 0 on the card that is installed in
slot 0.
Assigns an IP address and subnet mask to the interface.
13