Configuring The Gigabit Ethernet Switch Module Using The Management-Module Web Interface - Cisco Ethernet switch Installation Manual

3. Open a console window and make sure that the serial port is configured
with the following settings:
v 9600 baud
v 8 data bits
v No parity
v 1 stop bit
v No flow control
4. Type the user name and password. The default user name is USERID. The
default password is PASSW0RD (where 0 is a zero).
The serial port is compatible with the standard 16550 Universal Asynchronous
Receiver/Transmitter (UART) protocol. The RS-232 serial port is enabled by
default. The serial interface cable provides a female DB-9 connector to the RJ45
connector.
Configuring the Gigabit Ethernet switch module using the
management-module Web interface
This section describes how to use the management-module Web interface to
access and configure the internal switching software.
This section also describes some of the Web interface switch-module
management features.
The Gigabit Ethernet switch module offers an embedded HTML, Web interface
that you can use to manage the switch through Netscape
Navigator/Communicator, or Microsoft
enabled by default. The Web browser acts as an access tool and can
communicate directly with the switch using HTTP. Your browser window
might vary from the window illustrations in this document. You can access the
Web interface only through HTTP port 80. Your computer might have to access
and install a Java plug-in (JRE 1.4.0) to run without errors. Later versions of
the JRE might work but are not officially supported.
Note: This Web interface does not accept Chinese language input (or other
double-byte character-set languages).
Because the Web interface is a built-in component of the Cisco IOS software,
you do not have to install a separate interface program. See the documentation
that came with your software for more information about the Web interface.
Before you can access and start the Web interface, make sure that you have
completed the following procedures:
v Install the Gigabit Ethernet switch module in the BladeCenter unit
®
Internet Explorer. This interface is
Chapter 3. Configuring the Gigabit Ethernet switch module
27