Cisco CRS-1 - Carrier Routing System Router Getting Started Manual page 92

Bringing Up a Single-Chassis System for the First Time
show version Command
To display basic information about the router configuration, type the show version command in EXEC
mode, as shown in the following example:
RP/0/RP0/CPU0:router# show version
Cisco IOS-XR Software, Version 1.0.0
Copyright (c) 2004 by cisco Systems, Inc.
ROM: System Bootstrap, Version 1.15(20040120:002852) ,
router uptime is 2 days, 1 hour, 59 minutes
System image file is "tftp://223.0.0.0/usr/comp-hfr-full.vm-1.0.0
cisco CRS-16/S (7450) processor with 2097152K bytes of memory.
7450 processor at 650Mhz, Implementation , Revision
4 Packet over SONET network interface(s)
4 SONET/SDH Port controller(s)
1 Ethernet/IEEE 802.3 interface(s)
2043k bytes of non-volatile configuration memory.
1000592k bytes of ATA PCMCIA card at disk 0 (Sector size 512 bytes).
Configuration register is 0x2
Package active on node 0/2/SP:
hfr-admin, V 1.0.0, Cisco Systems, at mem:hfr-admin-1.0.0
Built on Fri Mar
--More--
show environment Command
To display environmental monitor parameters for the system, use the show environment command in
EXEC mode. The following command syntax is used:
show environment [all | fans | leds | power-supply | table | temperatures | voltages | l]
Table 4-1
Table 4-1
Syntax
all
fans
leds
power-supply
table
temperatures
voltages
|
Cisco CRS-1 Series Carrier Routing System Getting Started Guide
4-10
5 19:12:26 PST 2004
defines the show environment command syntax.
show environment Command Syntax
Displays
Information for all environmental monitor parameters.
Monitor parameters for system fans.
Monitor parameters for LEDs on all cards in the node.
Power supply voltage and current information.
Environmental parameter ranges.
System temperature information.
System voltage information.
Monitor parameters for output modifiers.
Chapter 4 Bringing up a New Cisco CRS-1 Router