Lexicon 300L - REV Owner's Manual page 92

Dual Delays Page Two
DL1 and DL2 set the delay values for the respective left to left and right to right
feedback loops
* A quick "double-click" on the DL1 or DL 2 slider button will allow you to control
the delay with more resolution. To exit this fine control mode, double-click on the
button again.
FB1 and FB2 set the gain of feedback for each of the delay lines. Available values
range from -99% to +99% gain.
Dual Delays Page Three
APD1 and APD2 are diffusors (All Pass Delays) in series with the feedback loops
associated with DL1 and DL2. Their controls range from 0 to 10 ms. These
controls essentially "tune" the diffusor delay line.
AP1 and AP2 are gains associated with the diffusors. You can think of them as
controlling the amount of diffusion.
Dual Delays Page Four
DL3 controls the delay time which cross-feedbacks to the input of DL2. DL4
controls the delay time which cross-feedbacks to the input of DL1.
* A quick "double-click" on the DL3 or DL 4 slider button will allow you to control
the delay with more resolution. To exit this fine control mode, double-click on the
button again.
FB3 and FB4 control the gain of the cross- feedbacks going with each of their
respective delay lines.
Dual Delays Page Five
LDL sets the left channel delay line's time. RDL sets the right channel delay line's
time.
* A quick "double-click" on the LDL or RDL slider button will allow you to control
the delay with more resolution. To exit this fine control mode, double-click on the
button again.
LPAN adjusts the left delay channel pan placement. RPAN adjusts the right
delay channel pan placement
The Algorithms and their Parameters
DL1*, DL2*
FB1, FB2
APD1, APD2 (All Pass Left
and Right Delays)
AP1, AP 2 (All Pass Left
and Right Gain)
DL3*, DL 4*
FB3, FB4
LDL*, RDL*
LPAN, RPAN
4-27