Lexicon 300L - REV Owner's Manual page 61

300L Owner's Manual
Page Three
CopyProtect (on, off),
Bypass/Mute, Program
Load, Memory Purge
Page Four
Offline Copy Tools
3-30
SCM (Serial Copy Management System)
If you have selected S/PDIF as the output format, this slider will allow you select
from among three levels of Copy Protection. The choices are: MULTI-COPY,
ONE COPY, OR NO COPY. The factory default setting is MULTI-COPY.
COPY
COPY PROTECT
Set this slider to OFF to allow copy functions to work. Select ON to protect
register locations. The factory default is ON.
BYP (Bypass)
This slider lets you determine the action of MUTE button: INPUT MUTE or
BYPASS DRY. In split Setups, the MUTE button affects both machines. With
INPUT MUTE selected, pressing the MUTE button will cause the message:
"AUDIO MUTED" to be displayed briefly. With BYPASS DRY selected, pressing
MUTE will cause the message: "AUDIO BYPASS" to be displayed. The factory
default setting is INPUT MUTE.
LOAD (Program Load)
This control allows you to determine to behavior of the 300L on program load:
BYPASS DRY or MUTE. The factory default is MUTE. Note: On configuration
changes, audio is muted regardless of selection.
PURGE
This slider allows you to perform five types of memory purges: Setup Registers,
Effect Registers, MIDI Map, Time Code Event List, or Total Purge. Select the
type of purge you want, then press STO to purge your selection. Be careful!
These functions permanently erase user information.
Page 4 is an"offline" copy page that allows you to copy Setups, or Effects from
one location to another.
SETUP COPY - >
Slider 1 lets you to select Setups, or Effects to copy. You selection is shown on
both the upper and lower LARC display.
SRC (Source)
Depending on the selection made with Slider 1, the SRC slider scrolls through
all the Setup, and Effect locations. Presets are listed first, followed by Registers.
DEST (Destination)
This slider allows you to select the Register location where the copy will be
stored.
BYP LOAD
SRC
Lexicon
PURGE
DEST