Lexicon 300L - REV Owner's Manual page 114

P102 DM: REV/DLY
MA:B11P3 DRUM CHAMBER
REV/DLY utilizes a great sounding mono reverb for kick and snare. Machine B runs Faze Delays,
getting its signal from the right input. The LFO in the Setup runs at .24Hz with a triangle waveform.
The FDLY parameter in Machine B is patched to this LFO. The SoftSlider is patched to the Setups
balance controls. Advancing the SoftSlider will pan the left input stronger into Mach B and pan the
right input stronger into Mach A.
MA:B11P3 DRUM CHAMBER
Good starting point for acoustic drums. This preset is slightly larger than the standard chamber, but
has less Diffusion. Rt is set to 1.0 second at mid frequencies.
MB:B12P7 LFO:FAZE DELAYS
Faze Dlys makes use of the LFO patched to the Flange Glide Delay(FDLY). The base delays are
set in different time domains: one side at 1.9ms with a feedforward gain; the other at 5.6 with a
negative feed gain. As the Glide passes over each base delay, the phase of each gain is changed.
In between, the output is a mixture of each. A great effect on a ripping guitar solo.
P103 DM: REV/PCH
MA:B13P4: GUITAR ROOM
This Dual Mono preset will get you set for your guitar tracks. The LFO is set to 0.24. Increase the
rate to increase the pitch glide in the Guitar Shift Effect preset. The SoftSlider is patched to the
Setup's balance controls. Advancing the SoftSlider will pan the left input stronger into Mach B and
pan the right input stronger into Mach A
MA:B13P4 GUITAR ROOM
This is a big, wide-sounding room for your guitars. For heavy rock stuff, you might consider panning
"in" the returns, although in this Setup the Room output is in Mono. The room is a little bottom heavy
for additional warmth. Could also work well on vocals.
MB: B15P2 GUITAR SHIFT
This preset offers a medium amount of micropitch shift (-14c), along with a small amount of
recirculating predelay. Actually, the glide pitch parameter (GLD) is patched to the LFO running in the
Setup. The LFO causes the GLD to glide between -14 and -+7 cents. If you turn off the LFO on Setup
page 4, then return to program edit and move the GLD parameter to -21c, the preset becomes
raunchy sounding on "beefy" guitars.
P104 DM: REV/COMP
MA:B14P9 PLATE
This preset utilizes a plate preset on the left input and a compressor preset on the right input.
Typically, EZ Comp2:1 should be used at a patch point on the console. If used on an effect send,
make sure the fader sends are pre-fade, or a "time phase" error will occur between the fader signal
and the return to the console.
MA: B14P9 PLATE
Very bright, very diffuse with an preset reverb time or 1.47 secs.
MB: B16P1 EZ COMP 2:1
An "easy" preset to add to an overall stereo mix or mono or stereo submix. You might need to adjust
Threshold to make it work for the particular signal you feed it. Release is set to gently (2:1) fall away
after 363ms.
SoftSlider INPUT PAN
MB:B12P7 LFO: FAZE DELAYS
SoftSlider INPUT PAN
MB:B15P2: GUIT SHIFT
SoftSlider INPUT PAN
MB:B16P1 EZ COMP2:1
0
0
0
The Presets
5-11