Softslider - Lexicon 300L - REV Owner's Manual

When the 300L is first powered up, the upper LARC display should read:
LARGE HALL
SG: SET P 1
The slider displays should read:
SETUP:
indicating that the unit is in Setup mode. If your unit is not in Setup mode, press
the SETUP key. This simple keystroke will always take you to the top level of the
user interface.
Use the Setup PREset slider or enter a preset number via the numeric keypad
to cue a new setup into the display window. The cued setup number will blink.
Press ENTER to load the displayed Setup — and the Effect(s) associated with
it. The upper LARC display will flash "LOADING" while the Setup loads, and
"LOADED" once Setup loading is complete. This process can take several
seconds when the Setup includes reconfiguration of machines, I/O, etc.
The REG slider accesses 50 Setup Registers where you can store your
customized setups. Move the REG slider or press the button beneath the slider,
then enter a register number via the numeric keypad to cue a nd display a new
register. Press ENTER to load the displayed register. A quick "double-click" of
the button below the PRE or REG slider will put the slider into a fine resolution
mode. The slider will then cue up + or – x presets from its current position. Double
click again to exit the fine mode.
In the Setup mode, the rightmost slider (labeled SOFT) is designated as a soft
controller. Setup and/or Effect parameters can be patched to this slider for easy
access to the most useful parameters of any given effect. We have already
designed Soft Slider patches for all of the Single setups, and for most of the Dual
Mono and Cascade setups. For example, most of the Hall programs have RTM
(reverb decay) patched to the SoftSlider, while Chorus or Flange types of sounds
may have the LFO rate or feedbacks patched to the SoftSlider.
-24 18 12 6 0 6 +12 ovld dB
PRE REG
L
R
SOFT
System Operation

SoftSlider

3-3