Snapping Events; Editing The List - Lexicon 300L - REV Owner's Manual

300L Owner's Manual

Snapping events

Editing the Event List
6-4
The easiest way to develop a list in the 300L is to SNAP entries into the list. To
use the snap function, locate the source machine to the beginning of the section
you want to experiment with. Give yourself at least 5 seconds of pre-roll
timecode, as you will want to snap the first timecode value ahead of any audio.
Start timecode running and press the button under the SNAP slider to capture
the first timecode event. The upper display will show the number of the snapped
event, the type of valid time code, and the snapped timecode:
The lower display will show running timecode.
SNAP 0 0 :
To clear the last snapped event, press the button under the CLR slider. Pressing
CLR repeatedly will delete additional list events.
Time code formats are indicated as follows:
V:S
V:D
V:E
V:F
Press the PAGE key to go to Page 8. This is the Event Edit page. Editing the
list includes editing "snapped" time codes, direct entry of time codes, trimming
time codes, adding/deleting events from the list, choosing the type of automation
change, and selecting the event.
EDIT TC
The EDIT slider has 50 EDIT positions, 50 ADD positions and 50 DEL(delete)
positions. Advance the slider to move through all 150 positions.
The TC slider allows you trim the displayed time code for the current event entry
by + 4 seconds. The slider's null position is at the halfway point.
The button under the TC slider accesses a display page which allows you to
enter a new number via the keypad, assign new values for Hours, Minutes,
Seconds, or Frames via sliders, or trim the displayed time code again by + 4
seconds. Press the button below the EXIT slider to return to the Edit page with
the newly assigned number displayed. Press STOre to save the edit.
#1 SNAP V:S
nn : nn : nn : n n
-24 18 12
0 0 : 0 0 :
valid SMPTE Non-Drop
valid SMPTE Drop Frame
valid EBU
valid Film
TYPE SEL
Lexicon
L
6 0 6 +12 ovld dB
R
0 5 CLR