Lexicon 300L - REV Owner's Manual page 132

Digital effects/larc interface
Hide thumbs Also See for 300L - REV:
Table of Contents

Advertisement

B16P1 EZ COMP 2:1 An "easy" preset to add to an overall stereo mix or mono or stereo submix.
You might need to adjust Threshold to make it work for the particular signal you feed it. Release is
set to gently (2:1) fall away after 363ms.
B16P2 DRUMCOMP 3:1 This is a bit more aggressive, with 7dB of boost below the selected
threshold. A quick release of 58ms snaps up the volume. As with all compressor presets, Threshold
is the critical parameter.
B16P3 VOICE OVER A fairly aggressive voice compressor, with 7dB of boost below the preset
threshold of -17dB. A quick release of 58ms snaps up the volume. As with all compressor presets,
Threshold is the critical parameter.
B16P4 COMP 4 VERB This compressor preset was made to work after a reverb effect. The Slope
ratio is less than 2:1 with 5dB of gain below the -14dB threshold. The release is set to work fast at
91 ms.
B16P5 SMAKO! Alot of gain (13dB) with alot of slope (4:1) with the Threshold a couple of bits down
from Dbfs. Careful !! You may need to adjust Threshold to make it work for the particular signal you're
feeding it. The release parameter rips the signal up within 91ms.
B16P6 SMALL ST.ADJ This preset is a cut down version of the larger Stereo Adjust program
available in Single Setups. Level, Balance, Rotate, separate Left and Right Bass and Treble, along
with Spatial EQ are available. There are no SoftSlider patches in this preset.
B16P7 PANOLA A stereo adjust program with the Balance set to full left. The Balance parameter
is patched to the LFO. If loaded into a Setup which has the LFO running, Panola will cause the audio
to move between the left and right speakers.
B16P8 FILTER PASS This program is meant to reduce the bandwidth of the source audio. The
SoftSlider is patch to the Bass crossover and Treble Crossover parameters. When this Program is
loaded into another Setup the Bandpass will be set to what ever the SoftSlider value is set to.
B16P9 SPATIAL EQ A cut down version of the larger Stereo Adjust program available in Single
Setups. This particular preset has the Soft knob patched to three parameters: Spatial EQ (SPEQ),
Bass Left (BASL), and Bass Right (BASR) boosts and cuts.
B16P0 PONS+DITHER This program has dither turned on and set to PONS (Psycoacoustically
Optimized Noise Shaping), with level of 32. Experiments have shown this to be an optimum starting
level of dither.
The Presets
Bank 16
Mastering
5-29

Advertisement

Table of Contents
loading

Table of Contents