Lexicon 300L - REV Owner's Manual page 150

THR (Threshold)
Use this slider to set the point below whcich contoller values will not have an
effect on the parameter.
VAL (Value)
This slider lets you conveniently set the parameter value against the current
controller value. This obviates the need to go to the actual parameter location.
*NOTE: If the SRC controller is dynamic in nature, like a modulating LFO, setting
VAL may be difficult, as you will be trying set the parameter to a moving target.
In cases like this, turn the LFO OFF.
To better understand the 300L MIDI patching system, let's review the Soft Slider
patch in Setup #1 LARGE HALL.
1. Press SETUP.
2. Use the PRE slider to select SETUP #1 LARGE HALL.
3. Press the button under the SOFT slider. The display will show:
DECAY
64
This shows the name of the parameter the SoftSlider is assigned to, as well as
the stored value of the SoftSlider. Keep this value in your head as we proceed
with this example.
4. Press PROG, PAGE, then 6, to go to page 6 of the LARGE HALL Effect.
5. Press the SEL slider button. The display will show:
300 MACH A
MOD PATCH #1
L
-24 18 12 6 0 6 +12 ovld dB
R
L
-24 18 12 6 0 6 +12 ovld dB
R
MIDI Operation
7-7