Lexicon 300L - REV Owner's Manual page 46

The lower displays over the slider will read:
SEL SRC
Slider 1 (SEL) addresses the patch you are creating. Advancing the slider will
address either Patch #1 or Patch #2. For this example, pull the slider down to
create patch #1.
Slider 2 (SRC) assigns a control source which will drive the destination
parameter. Press the button directly under the slider to display:
OFF
NO PATCH
Advance the slider and the top display line will scroll through all the available
MIDI and non-MIDI source controllers. (The last source selection is LFO.)
Slider 3 (DEST) behaves in the same way. This slider determines what Setup
parameter (the DESTination) will be controlled by the LFO. For this example,
slowly advance the slider until the display shows ANALOG BAL (Analog
Balance).
Press the button under the SCL slider to display:
SCALE: 100%
THRESH: 0
Sliders 4 and 5 work together to yield the overall control mechanism to the
selected destination parameter (in this example, Analog Balance). For this
example, we will not change these controls.
Slider 6 (VAL) allows you to set the displayed parameter value to the source
controller's current value. Note that changing VAL will, in most cases, require you
to modify the scale value.
Go to Page 4 (press PAGE, followed by number 4) and set the LFO rate to 1.00
Hz. To view the parameter being modified, go to Page 2 and press the button
under slider 3, ANA: BAL. This is the basic model for making MIDI/MOD patches
in the 300L.
DEST SCL
TO
-24 18 12 6 0 6 +12 ovld dB
-24 18 12 6 0 6 +12 ovld dB
THR VAL
L
R
L
R
System Operation
3-15