Working With The Effect Programs - Lexicon 300L - REV Owner's Manual

The 300L is shipped with 160 Effect programs within the Setups described
earlier. Sooner or later you will want to alter the sounds of these effects to more
perfectly fit your requirements. To do this, load, for example Setup P1 LARGE
HALL, then press the PROG button. The upper display will show:
LARGE HALL
300MA: B01P1
This display tells you the name of the Effect Program which is currently in the
Setup, identifies the 300L and the Machine( in this case Machine A), along with
the Bank and Program location. At the same time the legends over the sliders
will change to show a page of effect parameters. The algorithms and their
parameters are described in detail in Chapter 4. We've chosen the first page of
Random Hall parameters to show here as an example:
RTM SHP
Pressing any of the buttons directly below the sliders will display the current
value of the selected parameter. In this example, pressing the button under the
RTM slider will display:
MID RT
2.03 SEC
Moving the slider will change the value of the mid reverb time. (Depending on the
original starting position of the slider, it may be necessary to "null" the slider
before it assumes control of the parameter.) Parameters can be adjusted over
their entire range with the slider. The PAGE key is used to access additional
parameter pages.
When you select a new page, any previous edits remain intact. If a new Setup
or Effect Progam is loaded, however, edits will be lost unless you have stored
them.
-24 18 12 6 0 6 +12 ovld dB
SPR SIZ
-24 18 12 6 0 6 +12 ovld dB
L
R
HFC PDLY
L
R
System Operation
Working with the
Effect Programs
3-17