Using Banks And Programs - Lexicon 300L - REV Owner's Manual

The BANK and PROG keys can be used to load a new Effect (or Effects) into a
Setup. This is perfectly legal to do, but may seem counter-intuitive to the direct
Setup Select operation. For those familiar with 224XL or 480L operation, this
may seem more logical.
Load Setup 1, LARGE HALL. The name of the effect which is loaded into that
setup is also "Large Hall". If you press PROG, the display will show:
LARGE HALL
300MA: B01P1
indicating the Machine (MA), Bank (B1) and Program location (P1) for that Effect.
To load a different Effect into the Setup, press PROG repeatedly to locate the
Effect you want from that Bank. There are 10 Effects per Bank.
For example press PROG until the display reads:
DANCE HALL
300MA: B01P5
The Bank and Program location will flash to indicate that DANCE HALL is not the
Effect currently running in the current Setup. To load DANCE HALL (and make
it the currently running Effect) press 5 (for Program 5). The display will briefly
show: "PROGRAM LOADED", then revert back to display of the DANCE HALL
Bank and Program location without any flashing.
To go to another Bank, or to simply view the names of the different Banks, press
BANK repeatedly. All of the Banks will be shown sequentially. You can also
press BANK, then press a specific number key to display a particular Bank. For
example, press BANK, then press 5. The display will show:
DIALOG
300MA: B05P1
This display identifies DIALOG as the name of the Bank. The Bank and Program
location will flash to indicate the displayed Bank and Program location currently
running. If you are running a Single Setup, only Banks 1-0 and the Effects
continned in them are displayed and made available.
L
-24 18 12 6 0 6 +12 ovld dB
R
L
-24 18 12 6 0 6 +12 ovld dB
R
L
-24 18 12 6 0 6 +12 ovld dB
R
System Operation
Using Banks and
Programs
3-21