Lexicon 300L - REV Owner's Manual page 129

Lexicon
300L Owner's Manual
Effect Programs by
For convenient reference, the Split Setup program descriptions are repeated
here according to Bank location.
Bank
B11P1 BASIC DELAY Baseline effect with the SoftSlider patched to the Left and Right post delay
Bank 11
lines in the algorithm path. Their values are directly linked to the current position of the SoftSlider.
Basic Delays
B11P2 SLAP ECHO "In sync" slaps controlled by the position of the SoftSlider. No offsets between
channels.
B11P3 STEREO SLAPS Stereo left and right slap delays with the SoftSlider patched to left and right
Delays 1 and 2 as well and the Left and Right Post Delay outputs.
B11P4 SPACE EKOZ This program incorporates a bit of left-right diffused delays, along with some
small delay offset between left and right delay outputs. If the effect is too strong, try lowering feedback
levels for delays 3 and 4.
B11P5 PINGO PONGO Ping-Pong delays bouncing back and forth. The SoftSlider controls the
timing of the bounce.
B11P6 3VOICE DLYS Two taps (Delays 3 and 4 ) are set with delay ratios of 1:2, meaning that, when
one is 200ms, the other is 400ms, or when one is 359, the other is 718ms. This relationship is patched
to the SoftSlider.
B11P7 DUCKED EKOZ In this program, the amount of recirculating feedback varies with the input
level. The SoftSlider is patched to Delays 1 and 2, allowing you to quickly adjust the echoes to match
the tempo of the music or program content.
B11P8 CANYON EKOZ The delays in this program are static, but the amount of cross-feedback and
output panning is dependent on input level. The outputs are cross-patched to each meter. (The left
meter controls the right output pan and the right meter controls the left output pan.)
B11P9 PAN DELAYS This program incorporates two slightly out-of-sync recirculating delays under
SoftSlider control, along with output pans mapped to the internal LFO. Use the SoftSlider to match
the tempo of the music or program material.
B11P0 VOX DOUBLER The SoftSlider modifies Left and Right Delays 1 & 2. There is also a small
amount of cross-feedback via Left and Right Delays 3 and 4. Add Feedback and AP Gain as
described in SLAP ECHO. The Left and Right Post Delays are fixed at 53.513 ms.
Bank 12
B12P1 OVERTHETOP1 This program should be used pretty much through the box, i.e. patched to
Mod Delays
the LFO. When properly modulated, the flange delay glides between 9.5ms and 18.7ms. The base
delays are set to 10ms with a positive feedback gain. Over the top cancellation occurs as the glide
delay passes over the 10ms base delay.
B12P2 OVERTHETOP2 Similar to OverTheTop1, except the flange delay glides between 0.08 ms
and 10.7ms. This flange delay is patched to the LFO. Base delays are set to 10ms with a negative
amplifier gain. Over the top cancellation occurs as the glide delay passes over the 10ms base delay.
The channel outputs are reversed such that the left input will pass through to the right output and vice-
versa.
B12P3 CHORUS A small variation in the glide delay is used to modulate the sound. The glide moves
between 9.7ms and 11.8ms. Advancing the LFO to values near 1.50Hz to 2.0 Hz yields a nice
chorusing effect. There are no other delay lines, but the output lines are channel-swapped such that
the left input passes to the right output, and vice-versa.
B12P4 CHORUS+EKOZ Chorus+EKOz makes use of the flange gliding delay under the control of
the Setup LFO plus several recurring long echoes.
B12P5 NEGATIVEFLNG This is a really stiff flange which goes almost 20ms deep. Flange gain is
set extremely negative, so the sound is tunnel-like.
B12P6 ENV:PEAK Similar to an OverTheTop type effect except the flange delay is patched to meter
ballistics. Some modification of the scaling parameter on the MIDI / Mod Page 6, patch #1 may be
nessessary to suit the right Meter ballistics.
5-26