Lexicon 300L - REV Owner's Manual page 149

300L Owner's Manual
OFF
CNTLR- 0
MODWHEEL
BREATH
CNTLR-3
FOOTPED
PORTATIME
VOLUME
CNTLR-9
PAN
EXPRESSN
CNTLR-12-15
GPCNTRL1-4
CNTRL20-31
SUSTAIN
PORTA SW
SOSTENSW
SOFTPED
SWITCH68-79
GP CNTRL5-8
SWITCH84-95
PITCHWHL
AFTERTCH
LASTNOTE
LAST VEL
MIDI CLK
SOFTSLID
L-METER
R-METER
LFO
Available "Source" selections
7-6
SEL (Select)
This slider defines the current patch. In SETUP mode, this slider will go from 1
to 2. The upper display will read:
300 SETUP
PATCH #n
In PROG or REG mode,the upper display will read:
300 MACH A(B)
MOD PATCH #n
If you are currently running a Split Setup, and are in PROG or REG mode, the
MACH key is active. Pressing MACH will jump you to the other Machine. Go to
the patch page and press the button under the SEL slider. The display will show:
300 MACH B(A)
MOD PATCH #n
SRC (Source)
Use this slider to select the source controller which will control your selected
parameter.
DEST (Destination)
Use this slider to select the parameter to be modulated by the controller.
SCL (Scale)
Use this slider to set the effective range of your source controller. Scaling can
be set from -200% to +200%. When SCL is set to 100%, the full range of the MIDI
controller will correspond to the full range of the selected Destination parameter.
Setting a negative value will reduce the parameter value as the controller value
increases.
L
-24 18 12 6 0 6 +12 ovld dB
R
L
-24 18 12 6 0 6 +12 ovld dB
R
L
-24 18 12 6 0 6 +12 ovld dB
R
Lexicon