Lexicon 300L - REV Owner's Manual page 151

300L Owner's Manual
7-8
6. Press the SRC slider button. The display now gives you 2 pieces of
information; the controller source and parameter destination:
SOFTSLID TO
MID RT
Pressing the DEST slider does not change the display.
7. Press SCL or THR to display scale and threshold information.
SCALE:
THRESH:
8. The VAL slider allows you set the parameter value against the current MIDI
(or Non-MIDI) controller value.
MID RT
2.03 SEC
In this example. that value is 64. If you decide to modify this value, you will
effectively be introducing an offset to the original patch. This is perfectly
acceptable, but be aware that if you drastically offset the original parameter
value, the SoftSlider may very well drive that parameter into an OVER RANGE
or UNDER RANGE condition. In most cases, changing the VAL parameter
requires changing the Scale value as well.
In this case, the patch is made in the PROGram but controlled in the SETUP. To
store any changes you might make with either the SoftSlider or via MIDI, return
to SETUP mode, and press STOre. Select the Setup REGister you wish to store
into and press STOre again. This will automatically store the modified Machine
Effect into its own register as well as storing the Setup information into its own
Register.
-24 18 12 6 0 6 +12 ovld dB
45%
-24 18 12 6 0 6 +12 ovld dB
0
-24 18 12 6 0 6 +12 ovld dB
Lexicon
L
R
L
R
L
R