Storing A Setup - Lexicon 300L - REV Owner's Manual

300L Owner's Manual

Storing a Setup

3-16
To disable the patch, press SETUP, press the button under the PRE slider, then
press ENTER to re-select the Setup, thereby restoring the original settings.
Page 6 is a dedicated page for naming the Setup with as many as 12 characters.
The two active sliders are sliders 1 and 6. Slider 1 selects the character. Slider
6 changes the character. We strongly encourage you to rename setups
whenever storing a setup.
If you make changes to any of the setup parameters, and want to save your
changes into a Setup Register, press STOre. The display will show:
AVAILABLE
SG: SET R 1
The top line of the display shows the name of the Register slot where the modified
Setup will be stored. If "AVAILABLE" is displayed, the register is empty.The
bottom line, which shows the register location where your setup will be stored,
will flash to indicate you are in the middle of a store routine. If you want to store
the setup into a different register than the one displayed, use the REGister slider
to select a different location. Press STOre again. The display will briefly read:
STORED
SG: SET R 1
Then will revert to the previous display (LARGE HALL SG: SET R 1).
This store process also saves the effect which is part of the Setup.
Note: The 300L has a memory protection feature which enables or disables
copying data into any of the systems internal registers, be it Setup, Program,
Time Code, or MIDI. When Copy Protect is ON, all storing functions are
inhibited. Control mode, Page 3, Slider 1 will allow you set Copy Protect ON
or OFF. For more details, see the section describing Control mode at the end
of this chapter.
L
-24 18 12 6 0 6 +12 ovld dB
R
L
-24 18 12 6 0 6 +12 ovld dB
R
Lexicon