Setup Select - Lexicon 300L - REV Owner's Manual

To enter Setup mode, simply press the LARC key labeled SETUP. This mode
has six pages of controls:
Page 1 represents the top level of the User Interface. It allows you to select Setup
PREsets or REGisters, and to modify SoftSlider values. The Setup is identified
as SG: (SINGLE), DM: (DUAL MONO) or CC: (CASCADE).
The 6 LARC sliders are primarily used to adjust parameter values. At the top level
of the User Interface, the slider labeled SOFT can be used as a single or multi-
parameter controller linking one or more parameters within Setups and Effects.
Load Setup Preset SG:P1 LARGE HALL, which contains a single effect (Large
Hall), with the MID RT parameter mapped to the SoftSlider.
The LARC should display:
LARGE HALL
SG: SET P 1
Press the button below the SOFTSlider. The LARC will now display:
DECAY
The display changes to show the label associated with the SoftSlider plus the
stored value. Advance the SoftSlider and the sound of the effect will change. If
you want to return to the original sound press the button under the PRE slider,
then press ENTER.
Page 2 provides adjustment for analog and digital level and source balance into
the unified DSP engine. Simply press the key under the label of the control you
want to adjust and move the slider. As you adjust the slider, a long text message
will be shown in the display.
(The specific items available on this page are determined by the type of Setup
(Single, Dual Mono or Cascade) which is loaded.)
-24 18 12 6 0 6 +12 ovld dB
-24 18 12 6 0 6 +12 ovld dB
64

Setup Select

Example
L
R
L
R
System Operation
3-13