Stacker Bins - Xerox DocuPrint 100 Operator's Manual

Operator Guide

Stacker bins

Each output stacker bin has offsetting capability and a capacity
of 2500 sheets of 20 pound or 80 gsm paper.
NOTE: This capacity does not apply to 11 by 17 inch and A3
papers. Because of the additional weight these large sheets add
to the bins, each bin is restricted to hold only up to 1500 sheets
of A3 or 11 by 17 inch papers, for safety reasons.
Figure 1-9. High capacity stackers (HCS)
The stackers can stack the printed output in the bin three ways:
1. Directly onto the bin platform.
2. Into a container that is set on top of the bin platform.
NOTE: The stacking capacity is approximately 100 to 150
sheets less when stacking into a container.
3. Onto a pallet without a container (for paper sizes 11 by 17
inches or A3 only).
Using the Stacking windows on the user interface, you can select
the level to which paper will be stacked in the HCS.
A stacking elevator maintains the paper at the proper level for
stacking and lowers the stack for unloading. An offset
mechanism offsets printed sets toward the front or back of the
HCS bin.
The elevator platform lowers under the following conditions:
• The bin capacity has been reached.
• A selection to lower the platform is entered at the printer
control console or a user interface window.
• The job being printed reaches a designated unload
boundary.
Overview
1-23