Troubleshooting
5-56
•
Problem: The message display is blank.
1. Ensure that the tape drive is receiving power from the
main AC source.
2. Ensure that the AC power switch on the rear of the tape
drive is on.
3. Turn the DC power switch OFF(0) and then ON (1).
4. If the display is still blank, call for service.
•
Problem: The tape drive does not go into a Ready state.
1. Determine if the tape drive is online by pressing the Scroll
button until the message display shows the Status display.
2. If the tape drive is offline, refer to the section, "Placing the
tape drive online" in the "Managing the system" chapter.
Operator Guide