Troubleshooting; Error & Status Messages On The Display Panel - Ricoh Priport DX 4640PD Printer Reference

Error & Status Messages on the Display Panel
Messages/Second messages
Ethernet board Error.
Wireless card error.
Wireless board error.
Master Processing...
Memory switch error.
Optional RAM error.
Printing...
Parallel I/F board error.
DIMM value error.
HDD board error.
Print is not finished.
Ready<Online>

5. Troubleshooting

Descriptions and Solutions
An error has occurred in the Ethernet module.
Turn off the main power switch, and back on again. If the mes-
sage appears again, contact your sales or service representative.
IEEE 802.11b card was not inserted when the printer was turned
on, or it was pulled out after the printer turned on.
Turn off the printer and check the IEEE 802.11b card is inserted
correctly. Then, turn the printer on again. If the message ap-
pears again, contact your sales or service representative.
An error has occurred in the IEEE 802.11b module.
Turn off the main power switch, and back on again. If the mes-
sage appears again, contact your sales or service representative.
The master is being made.
An error has occurred in the memory unit.
Turn off the main power switch, and back on again. If the mes-
sage appears again, contact your sales or service representative.
An error has occurred in the SDRAM module.
Turn off the main power switch, and back on again. If the mes-
sage appears again, contact your sales or service representative.
Data is being printed.
Wait until the job is finished.
An error has occurred in the parallel I/F board.
Turn off the main power switch, and back on again. If the mes-
sage appears again, contact your sales or service representative.
An error has occurred in the PostScript3 bored.
Turn off the main power switch, and back on again. If the mes-
sage appears again, contact your sales or service representative.
An error has occurred in the HDD board.
Turn off the main power switch, and back on again. If the mes-
sage appears again, contact your sales or service representative.
Printing is not finished.
Printing has been interrupted. Perform one of the following
procedures:
• Press the {Start} key, and printing will restart. Before the
print amount display reaches 0, press the {Start} key to print.
• Press [End Printing] , and printing will stop. The interrupted
prints will not be performed.
Master Making or print data is on the spool. This is not an error.
Press the {Start} key to begin master making or printing.
77