Minitower 5 1/4-Inch Hard Disk Drive Cabling; Minitower 5 1/4-Inch Hard Disk Drive Cables - NEC POWERMATE 4100M Service Manual

Minitower 5 1/4-Inch Hard Disk Drive Cabling

Cable the hard disk drive per Figure 3-18 and the following steps.
Locate the IDE hard disk signal cable (connected to the 3 1/2-inch hard disk
1.
drive) and plug the middle connector into the signal connector on the hard disk
drive in the 5 1/4-inch slot (see Figure Section 3-37).
Either of the hard disk drive signal cable connectors may be used for the hard disk
drives. The hard disk drives are configured by jumpers as master (drive C) and
slave (drive D). The hard disk drive connectors are identified in Figure Section 3-
13.
2. Locate one of the larger power connectors coming from the power supply and
plug it into the hard disk drive power connector (see Figure Section 3-37).
Figure Section 3-37 Minitower 5 1/4-Inch Hard Disk Drive Cables
NOTE: When installing the drives, note that all
power and hard disk signal cables are keyed to fit
only in the correct position.
IDE
Cable
Options 3-35
Power
Cable