Minitower 5 1/4-Inch Device Placement; Minitower 5 1/4-Inch Device Screws - NEC POWERMATE 4100M Service Manual

Minitower 5 1/4-Inch Device Placement

Install the device into the 5 1/4-inch device slot as follows.
1. Remove the top cover, front panel as previously described.
2. Slide the rear of the device into the 5 1/4-inch slot. (Be sure that the load/release
button on the diskette drive is on the right when sliding the drive into the device
cage.)
Align the holes on the 5 1/4-inch device with the holes in the device cage.
3. Install the four device screws that were removed with the rails or that come with
the kit, two on each side of the drive cage (see Figure Section 3-33).
Figure Section 3-33 Minitower 5 1/4-Inch Device Screws
Continue to minitower 5 1/4-inch device cabling.
NOTE: When installing 3 1/2-inch hard disk
drives, a 5 1/4-inch hard disk bracket must first
be attached to the 3 1/2-inch hard disk drives.
2 of 4
Device Screws
Options 3-33