Front Panel Assembly Removal; Front Panel Screws - NEC POWERMATE 4100M Service Manual

Front Panel Assembly Removal

Remove the front panel assembly per Figure Section 6-6 and the following steps.
1. Remove the top cover as previously described.
Remove the seven front panel screws from inside the top cover (see Figure Sec-
2.
tion 6-6).
Feed the two lamp and reset cables through the hole in the front of system unit
3.
chassis when removing the front panel assembly.
Separate the lamps and reset button from the front panel assembly by pulling them
4.
out from their socket in the panel assembly.
1 of 7
Screws
Figure Section 6-6 Front Panel Screws
Minitower Repair 6-7
Top Cover
Inside
Front
Panel