6-16
Minitower Repair
5 1/4-Inch Device Cage Removal
Remove the 5 1/4-inch device cage from the system unit as follows.
1.
Remove the top cover as previously described.
2.
Unplug all signal and power cables from the device(s) in the 5 1/4-inch device
cage.
Remove the four device cage screws from the front of the device cage (see Figure
3.
Section 6-15).
4.
Pull the device cage out from the front of the system unit. Devices in the device
cage do not need to be removed to remove the device cage.
1 of 4 Device
Cage Screws
Figure Section 6-15 5 1/4-Inch Device Cage Screws
NOTE: Devices installed the device cage can be
removed from the device cage without removing
the device cage. See the previous procedure.
NOTE: The 3 1/2-inch diskette drive bracket
can be removed after the 5 1/4-inch device cage
is gone by removing the two 3 1/2-inch diskette
drive bracket screws shown in Figure Section 6-
15.
Device Cage