1/4-Inch Device Cage Removal - NEC POWERMATE 4100M Service Manual

5 1/4-Inch Device Cage Removal

Remove the 5 1/4-inch device cage from the system unit as follows.
1. Remove the top cover, front panel, and 3 1/2-inch drive bracket as previously de-
scribed.
2. Unplug all signal and power cables from the device(s) in the 5 1/4-inch device
cage (see Figure Section 5-19). The CD-ROM reader also requires the audio ca-
ble to be disconnected from the device.
Remove the four device cage screws from the front of the device cage (see
3.
Figure Section 5-21).
Pull the device cage out from the inside of the system unit. Devices in the device
4.
cage do not need to be removed when removing the device cage.
Figure Section 5-21 5 1/4-Inch Device Cage Screws
NOTE: Devices housed inside the device cage
can be removed from the device cage without
removing the device cage. See the preceding
procedure.
Remove the device cage only when completely
disassembling the system unit.
Desktop Repair
Device Cage
Device Cage
5-15