1/4-Inch Device Removal; Left Side Device Screw Access Holes - NEC POWERMATE 4100M Service Manual

5 1/4-Inch
Drive Screw
Access Holes
2 of 4
3 1/3-Inch Hard
Disk Drive Screws
(not shown)
Figure Section 6-14 Left Side Device Screw Access Holes
4. Remove the 3 1/2-inch hard disk drive out from inside the chassis.

5 1/4-Inch Device Removal

Remove a 5 1/4-inch device from the 5 1/4-inch device cage as follows.
1. Remove the top cover as previously described.
Unplug all signal and power cables from the device(s) in the 5 1/4-inch device
2.
cage (see Figure Section 6-13).
Remove the four 5 1/4-inch hard disk drive screws; two on each side.
3.
The two right side 5 1/4-inch hard disk drive shown in Figure Section 6-13. The
two left side 5 1/4-inch hard disk drive screws shown in Figure Section 6-14.
4. Remove the device out of the 5 1/4-inch device cage from the front of the system
unit.
Minitower Repair 6-15