Configuring Wan Ip - ZyXEL Communications ZyWALL 10W User Manual

ZyWALL Series Internet Security Gateway
LABEL
Retype to Confirm
Nailed-up
Connection
Idle Timeout
PPTP Configuration
My IP Address
My IP Subnet Mask
Server IP Address
Connection ID/Name
Apply
Reset
8.5

Configuring WAN IP

To change your ZyWALL's WAN IP settings, click WAN, then the WAN IP tab. This screen varies
according to the type of encapsulation you select.
If your ISP did not assign you a fixed IP address, click Get automatically from ISP (Default);otherwise
click Use fixed IP Address and enter the IP address in the following field.
8-8
Table 8-4 PPTP Encapsulation
Type your password again to make sure that you have entered it correctly.
Select Nailed-Up Connection if you do not want the connection to time out.
This value specifies the time in seconds that elapses before the ZyWALL
automatically disconnects from the PPTP server.
Type the (static) IP address assigned to you by your ISP.
Your ZyWALL will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the ZyWALL.
Type the IP address of the PPTP server.
Type your identification name for the PPTP server.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
WAN Screens