Editing Tcp/Ip Options; Figure 368 Menu 11.3.2: Remote Node Network Layer Options; Table 220 Menu 11.3.2: Remote Node Network Layer Options - ZyXEL Communications ZYWALL 35 User Manual

35.3.4 Editing TCP/IP Options

Move the cursor to the Edit IP field in menu 11.3, then press [SPACE BAR] to select Yes.
Press [ENTER] to open Menu 11.3.2 - Remote Node Network Layer Options. Not all fields
are available on all models.

Figure 368 Menu 11.3.2: Remote Node Network Layer Options

The following table describes the fields in this menu.

Table 220 Menu 11.3.2: Remote Node Network Layer Options

FIELD
IP Address
Assignment
Rem IP
Address
Rem Subnet
Mask
My WAN
Addr
ZyWALL 5/35/70 Series User's Guide
Menu 11.3.2 - Remote Node Network Layer Options
IP Address Assignment= Static
Rem IP Addr= 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
Network Address Translation= SUA Only
NAT Lookup Set= 255
Metric= 15
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
DESCRIPTION
If your ISP did not assign you a fixed IP address, press [SPACE BAR] and then
[ENTER] to select Dynamic, otherwise select Static and enter the IP address and
subnet mask in the following fields.
Enter the (fixed) IP address assigned to you by your ISP (static IP address assignment
is selected in the previous field).
Enter the subnet mask associated with your static IP.
Leave the field set to 0.0.0.0 to have the ISP or other remote router dynamically
(automatically) assign your WAN IP address if you do not know it. Enter your WAN IP
address here if you know it (static).
This is the address assigned to your local ZyWALL, not the remote router.
Chapter 35 WAN and Dial Backup Setup
615