Chapter 8 WAN Screens
Table 36 NETWORK > WAN (General) (continued)
LABEL
Allow Trigger Dial Select this option to allow NetBIOS packets to initiate calls.
Apply
Reset
8.8 Configuring Load Balancing
To configure load balancing on the ZyWALL, click NETWORK > WAN in the navigation
panel. The WAN General screen displays by default. Select Active/Active Mode under
Operation Mode to enable load balancing on the ZyWALL.
The WAN General screen varies depending on what you select in the Load Balancing
Algorithm field.
8.8.1 Least Load First
To configure Least Load First, select Least Load First in the Load Balancing Algorithm
field.
Figure 94 Load Balancing: Least Load First
The following table describes the related fields in this screen.
Table 37 Load Balancing: Least Load First
LABEL
Active/Active
Mode
Load Balancing
Algorithm
176
DESCRIPTION
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
DESCRIPTION
Select Active/Active Mode and set the related fields to enable load balancing on
the ZyWALL.
Set the load balancing method to Least Load First.
ZyWALL 5/35/70 Series User's Guide