ZyXEL Communications ZYWALL 35 User Manual page 621

Table 223 Menu 11.2: Remote Node Profile (3G WAN) (continued)
FIELD
Retype to
Confirm
Authen
Pri Phone #
Edit IP
Edit Script
Options
Always On
Session
Options
Edit Filter sets
Idle Timeout
Once you have configured this menu, press [ENTER] at the message "Press ENTER to Confirm..." to
save your configuration, or press [ESC] at any time to cancel.
ZyWALL 5/35/70 Series User's Guide
DESCRIPTION
Enter your password again to make sure that you have entered is correctly.
This field sets the authentication protocol used for outgoing calls.
Options for this field are:
CHAP/PAP - Your ZyWALL will accept either CHAP or PAP when requested by this
remote node.
CHAP - accept CHAP only.
PAP - accept PAP only.
Enter the phone number (dial string) used to dial up a connection to your service
provider's base station. Your ISP should provide the phone number.
For example, *99# is the dial string to establish a GPRS or 3G connection in Taiwan.
This field leads to a "hidden" menu. Press [SPACE BAR] to select Yes and press
[ENTER] to go to Menu 11.3.2 - Remote Node Network Layer Options. See
Section 35.3.4 on page 615
Press [SPACE BAR] to select Yes and press [ENTER] to edit the AT script for the
dial backup remote node (Menu 11.3.3 - Remote Node Script). See
on page 616 for more information.
Press [SPACE BAR] to select Yes to set this connection to be on all the time,
regardless of whether or not there is any traffic. Select No to have this connection act
as a dial-up connection.
This field leads to another "hidden" menu. Use [SPACE BAR] to select Yes and press
[ENTER] to open menu 11.3.4 to edit the filter sets. See
for more details.
Enter the number of seconds of idle time (when there is no traffic from the ZyWALL to
the remote node) that can elapse before the ZyWALL automatically disconnects the
3G connection. .
Chapter 35 WAN and Dial Backup Setup
for more information.
Section 35.3.5
Section 35.3.6 on page 618
621